Starting Echo Chainsaw First Time. Gasoline will deteriorate over time and start to form gum and varnish. In either case, your goal is to get the fuel flowing and get your saw’s engine warm enough to fire.
The engine will have time to warm up and then the handle chain brake should be released. Over time, they can become sooty and clogged. Remove the starter spring and inspect it to see if it is functioning properly.
this
You never want to start the chainsaw in the air or on a surface that is too high and awkward. Dan shows you how to properly cold start and warm start an echo chain saw. An engine spark arrestor is a small screen that prevents sparks from escaping the engine.
If the engine is hot, you can start immediately after starting. Place the echo chainsaw on the ground. If the recoil starter assembly is defective, the engine won’t turn over and the chainsaw won’t start.
Place the chainsaw on the ground and put your right foot through the rear handle. Here we will discuss some common issues and solutions for echo chainsaw troubleshooting. The fuel tank might be empty, or the fuel might have gone bad.
Put your right foot on the rear handle with the chainsaw on the ground. As soon as the chainsaw starts, you should let it run for 1 minute without turning the disengage the chain brake with a medium throttle. Open the choke and use the fuel primer to pump fuel into the carburetor.
Let the engine run a while. Switch the saw to on in the control switch. Clogged spark arrestors may cause a chainsaw to run rough or stall.
:format(jpeg):mode_rgb():quality(90)/discogs-images/R-5094070-1384305383-6215.jpeg.jpg)
